Руководство По Проектированию для Cisco Cisco Nexus 5010 Switch
Design Guide
If the PortChannel is spread across two Cisco Nexus 5000 or 7000 Series Switches, the configuration of the
PortChannel looks as follows:
PortChannel looks as follows:
interface port-channel60
switchport
switchport mode access
switchport access vlan 60
vpc 60
Assigning VLANs
After bonding the adapters, you can partition the teamed adapters with VLANs as shown in Figure 4.
Figure 4.
VLAN Assignment
With this configuration, the upstream switch port needs to be configured as a trunk port, allowing the VLANs that are
configured on the teamed adapter.
configured on the teamed adapter.
If more than one VLAN is defined on a given team of adapters, the teaming software creates a new adapter for the
newly defined VLAN.
newly defined VLAN.
If the PortChannel team is spread across two Cisco Nexus 5000 or 7000 Series Switches, then the configuration of
the PortChannel looks as follows:
the PortChannel looks as follows:
interface port-channel60
switchport
switchport mode trunk
switchport access vlan 60
switchport trunk allowed vlan 50,60
vpc 60
spanning-tree port type edge trunk
© 2010 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 10 of 17