Руководство По Устранению Ошибки для Cisco Cisco Packet Data Gateway (PDG)
System Element Configuration Procedures
Creating and Configuring Frame Relay Interfaces and Ports ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22970-01
With releases 8.1 and higher, we recommend that you include the signal type, either
or
, when defining
the framing.
With releases 8.1 and higher, you need to set the
for the CLC card to
, all
other options are not fully supported at this time.
Configuring the Channel Characteristics
Use the following example to configure the path, framing, mapping, timeslots, and the Frame Relay interface and LMI
characteristics for a specific CLC port:
characteristics for a specific CLC port:
I
MPORTANT
:
You should make a record of the values you enter as the information will be needed again for
additional configuration of the
command.
Configuring and Binding a DLCI
Use the following procedure to configure the data link connection identifier (DLCI) and bind the DLCI to the
channelized (Frame Relay) port:
channelized (Frame Relay) port:
I
MPORTANT
:
This procedure should not be attempted until after the 2G SGSN configuration is completed for
Peer-NSEIs and/or SS7 routing domains as described in the SGSN Administration Guide with command details in the
Command Line Interface Reference.
Command Line Interface Reference.