Руководство По Работе для Brother CS7205
SEWING BASICS
26
3
Press (stitch selection keys) to designate
the desired stitch number.
the desired stitch number.
1
Designates the tens digit.
2
Designates the ones digit.
X
The stitch is selected.
4
Attach the presser foot indicated in the LCD.
1
Presser foot type
• For details, refer to “Replacing the presser
foot” (page 23).
Adjusting the stitch length and
width
■
[Example] Selecting stitch .
1
Press (stitch selection keys) to select
stitch 05.
stitch 05.
2
Press the “+” or “–” side of
(stitch length
adjustment key) to increase or reduce the
stitch length.
stitch length.
1
Stitch length
2
Stitch length adjustment key
3
Short
4
Long
3
Press the “+” or “–” side of
(stitch width
adjustment key) to increase or reduce the
stitch width.
stitch width.
1
Stitch width
2
Stitch width adjustment key
3
Narrow
4
Wide
Note
• When the stitch length or stitch width is changed
from the standard setting, around or
disappears from the LCD.
disappears from the LCD.
CAUTION
• After adjusting the stitch width, slowly turn
the handwheel toward you (counterclockwise)
and check that the needle does not touch the
presser foot. If the needle hits the presser foot,
the needle may bend or break.
• If the stitches are bunched together, increase
the stitch length. Continuing to sew with the
stitches bunched together may result in the
needle bending or breaking.
Starting to sew
1
Raise the needle in the following way.
or
1
Turn the handwheel so
that the mark on the
wheel points up.
that the mark on the
wheel points up.
2
Press the Needle position
button (for the models
equipped with this button).
button (for the models
equipped with this button).
2
Raise the presser foot lever.
1
Presser foot lever
3
Place the fabric under the presser foot, pass
the thread under the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
the thread under the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
1
5 cm (2 inches)