Руководство По Работе для Brother CS7205
UTILITY STITCHES
44
X
The feed dogs are lowered.
5
Turn on the sewing machine, and then select
a stitch.
a stitch.
6
Use both hands to hold the fabric taut, then
move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of sewing.
move the fabric to follow the pattern.
Reinforcement stitches are sewn at the
beginning and end of sewing.
1
Pattern
7
After sewing is finished, slide the feed dog
position lever to
position lever to
and turn the handwheel
to raise the dogs.
• Normally, the feed dog position lever is
• Normally, the feed dog position lever is
positioned at
.
REINFORCEMENT
STITCHING
Reinforce points that will be subject to strain, such as
sleeve holes, inseams and pocket corners.
sleeve holes, inseams and pocket corners.
Stitch Name
Pattern Presser Foot Pattern No.
Triple stretch
stitch
J
03
Bar tack stitch
A
45
CAUTION
• Be sure to turn off the main power before
replacing the presser foot. Otherwise, injuries
may occur if the foot controller or (start/
stop button) is accidentally pressed and the
machine starts sewing.
Triple stretch stitching
Use triple stretch stitching to reinforce sleeve holes
and inseams.
and inseams.
1
Attach zigzag foot “J”.
2
Select stitch .
3
Start sewing. (Refer to page 26.)
Bar tack stitching
Bar tacks are used to reinforce points subject to
strain, such as pocket corners and openings.
As an example, the procedure for sewing bar tacks at
pocket corners is described below.
strain, such as pocket corners and openings.
As an example, the procedure for sewing bar tacks at
pocket corners is described below.
1
Determine the desired length of the bar tack.
Set the button guide plate on buttonhole foot
“A” to the desired length. (One division on the
presser foot scale is 5 mm (3/16 inch).)
Set the button guide plate on buttonhole foot
“A” to the desired length. (One division on the
presser foot scale is 5 mm (3/16 inch).)
1
2
3
1
Presser foot scale
2
Length of bar tack
3
5 mm (3/16 inch)
• A bar tack with a maximum length of about
28 mm (1-1/8 inches) can be sewn.
2
Attach buttonhole foot “A”.
3
Select stitch .
4
Position the fabric so that the opening of the
pocket faces toward you, and then lower the
presser foot lever so that the needle drops
2 mm (1/16 inch) in front of the pocket
opening.
pocket faces toward you, and then lower the
presser foot lever so that the needle drops
2 mm (1/16 inch) in front of the pocket
opening.
1
1
2 mm (1/16 inch)
Pass the upper thread down through the hole
in the presser foot.
in the presser foot.