Руководство По Работе для Brother CS7130

KNOWING YOUR SEWING MACHINE

Memo

• When the sewing machine is started or the

handwheel is turned after winding the thread

around the bobbin, the machine will make a

clicking sound; this is not a malfunction.

• The needle bar does not move when you slide the

bobbin winding shaft to the right.

CAUTION

• Not winding the bobbin properly may cause

the thread tension to loosen, and may break

the needle.

Wound evenly

Wound poorly

■

For models equipped with the fast bobbin

winding system

Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin. Then slide the shaft to
the right.

Notch

Spring

Follow steps

through

of the procedure

in “Winding the bobbin” to pass the thread
around the pre-tension disk (page 10).

Wind the free end of the thread clockwise
around the bobbin five or six times.

Pull the thread and pass it through the slit in
the bobbin winder seat.

Slit (with built-in cutter)

The thread is cut to a suitable length.

CAUTION

• Be sure to cut the thread as described. If the

bobbin is wound without cutting the thread

using the cutter built into the slit, the thread

may become tangled in the bobbin or the

needle may bend or break when the bobbin

thread starts to run out.

(For models equipped with the sewing speed
controller)
Slide the sewing speed controller to the right
(to set the speed to fast).

Sewing speed
controller

Turn on the sewing machine.

Press the foot controller or press to start.

Note

• When using the foot controller to operate

the sewing machine, connect the foot

controller before turning on the machine.

• When the foot controller is plugged in, the

start/stop button is disabled (only for models

equipped with the start/stop button).

When the bobbin begins spinning slowly, take
your foot off the foot controller or press .

Cut the thread, slide the bobbin winder shaft
to the left, and then remove the bobbin from
the shaft.