Руководство По Работе для Brother CS7130
KNOWING YOUR SEWING MACHINE
20
Memo
• The smaller the thread number, the thicker the
thread; and the larger the needle number, the
thicker the needle.
■
Ball point needle
Use the ball point needle when sewing on stretch
fabrics or fabrics where skipped stitches easily
occur.
Use the ball point needle for best results when
sewing patterns using monogramming foot “N”.
fabrics or fabrics where skipped stitches easily
occur.
Use the ball point needle for best results when
sewing patterns using monogramming foot “N”.
■
Transparent nylon thread
Use a 90/14 to 100/16 needle, regardless of the
fabric or thread.
fabric or thread.
CAUTION
• The appropriate fabric, thread and needle
combinations are shown in the table on the
previous page. If the combination of the fabric,
thread and needle is not correct, particularly
when sewing thick fabrics (such as denim) with
thin needles (such as 65/9 to 75/11), the needle
may bend or break. In addition, the stitching
may be uneven or puckered or there may be
skipped stitches.
Checking the needle
Sewing with a bent needle is extremely dangerous
since the needle may break while the machine is
being operated.
Before using the needle, place the flat side of the
needle on a flat surface and check that the distance
between the needle and the flat surface is even.
since the needle may break while the machine is
being operated.
Before using the needle, place the flat side of the
needle on a flat surface and check that the distance
between the needle and the flat surface is even.
1
2
1
Flat side
2
Needle type
marking
3
4
3
Flat surface
4
Even
3
5
5
Not even
Replacing the needle
1
Raise the needle in the following way.
or
1
Turn the handwheel so
that the mark on the
wheel points up.
2
Press the Needle position
button (for the models
equipped with this button).
2
Turn off the sewing machine.
CAUTION
• Before replacing the needle, be sure to turn off
the sewing machine, otherwise injuries may
occur if the foot controller or the start/ stop
button is accidentally pressed and the machine
starts sewing.
3
Lower the presser foot lever.
1
Presser foot
lever
CAUTION
• Before replacing the needle, place fabric or paper
under the presser foot to prevent the needle from
falling into the hole in the needle plate.
4
Remove the needle by turning the needle
clamp screw counterclockwise.
clamp screw counterclockwise.
1
Disc-shaped screwdriver
2
Needle clamp screw
Note
• If the needle clamp screw is loosened too
much, the needle clamp (which holds the
needle) may fall off. Therefore, do not
loosen the needle clamp screw too much.