Руководство По Работе для Brother Innov-is 6000D
31
3
Specifying Stitching Settings
Lines of the drawing are sewn with satin stitches and areas are sewn with fill stitches.
The following settings can be specified.
The following settings can be specified.
1
Satin stitch (lines): thickness and stitch density
2
Fill stitch (areas): sewing direction and stitch density
If the drawing data is saved, the settings can be changed after a trial embroidery of the
design is sewn. (Refer to “Saving Image Data” on page 42.)
design is sewn. (Refer to “Saving Image Data” on page 42.)
1. Displaying the Stitching Settings
Screen
1
Press
.
2
The screen shown at the left appears.
1
Reduces the size of the pattern
The size of the drawn pattern can be changed. (Refer to
page 34.)
page 34.)
2
Specifies the width of the satin stitches used to sew the
lines of the drawing (Refer to page 32.)
3
Specifies the sewing direction for fill stitches (Refer to
4
5
Corrects shrinkage
When sewing embroidery, stitched areas may shrink. If
this happens, the stitching can be corrected to prevent
shrinkage. (Refer to page 47.)
this happens, the stitching can be corrected to prevent
shrinkage. (Refer to page 47.)
* To quit specifying settings, press
.
Notes
• You can use the pen tablet for operations in the stitching settings
• You can use the pen tablet for operations in the stitching settings
screen while moving tablet pen without touching tablet until you are
ready to make selection.
ready to make selection.
1
2
3
4
5