Руководство По Работе для Brother Innov-is 85e
Reinforcement Stitching 101
3
—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
c
Select stitch
52
.
• For details, refer to “Selecting stitching” (page
67).
d
Attach buttonhole foot “A”.
• For details, refer to “Replacing the presser
foot” (page 41).
e
Pass the upper thread down through the hole
in the presser foot, and then pull it under the
presser foot, as shown.
in the presser foot, and then pull it under the
presser foot, as shown.
f
With the opening of the pocket toward you,
position the fabric so that the needle drops 2
mm (1/16 inch) in front of the pocket opening,
and then lower the presser foot lever.
position the fabric so that the needle drops 2
mm (1/16 inch) in front of the pocket opening,
and then lower the presser foot lever.
a 2 mm (1/16 inch)
Note
z When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
bar tack will not be sewn with the correct
size.
bar tack will not be sewn with the correct
size.
g
Pull down the buttonhole lever as far as
possible.
possible.
a Buttonhole lever
The buttonhole lever is positioned behind the
bracket on the buttonhole foot.
bracket on the buttonhole foot.
a Buttonhole lever
b Bracket
b Bracket
h
Gently hold the end of the upper thread in
your left hand, and then start sewing.
your left hand, and then start sewing.
X
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
automatically sews reinforcement stitches,
then stops.
i
Cut the threads, raise the presser foot lever,
and then remove the fabric.
and then remove the fabric.
j
Raise the buttonhole lever to its original
position.
position.
Memo
z If the fabric does not feed, for example,
because it is too thick, increase the stitch
length. For details, refer to “Adjusting the
stitch length” (page 59).
length. For details, refer to “Adjusting the
stitch length” (page 59).
a
a
2
1