Руководство По Работе для Brother Innov-is 85e
Care and Maintenance 127
4
—— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
h
Insert the bobbin case so that the S mark on
the bobbin case aligns with the z mark on
machine as shown below.
the bobbin case aligns with the z mark on
machine as shown below.
• Align the S and z marks.
a
S
mark
b
z
mark
c Bobbin case
• Make sure that the indicated points are
• Make sure that the indicated points are
aligned before installing the bobbin case.
CAUTION
i
Insert the tabs on the needle plate cover into the
needle plate, and then slide the cover back on.
needle plate, and then slide the cover back on.
a Needle plate cover
j
Install the flat bed attachment in its original
position.
position.
Removing the needle plate
When the thread is tangled and cannot be removed
by cleaning the race, remove the needle plate.
by cleaning the race, remove the needle plate.
a
Follow steps
a
through
f
on page 126.
b
Remove the needle plate by removing the
screws with the included screwdriver.
screws with the included screwdriver.
c
Remove the tangled thread from the needle
plate.
plate.
d
Return the needle plate to its original position, and
then tighten the screws with the included screwdriver.
then tighten the screws with the included screwdriver.
Note
z Align the two screw holes on the needle
plate with the two holes on the machine.
e
Follow steps
g
through
j
(page 126-127).
● Never use a bobbin case that is scratched,
otherwise the upper thread may become
tangled, the needle may break or sewing
performance may suffer. For a new bobbin
case (part code: XE7560-001), contact your
nearest authorized service center.
tangled, the needle may break or sewing
performance may suffer. For a new bobbin
case (part code: XE7560-001), contact your
nearest authorized service center.
● Be sure that the bobbin case is correctly
installed, otherwise the needle may break.
a