Руководство По Работе для Brother Innov-is 4500D

UPPER THREADING

Using the Twin Needle Mode

The twin needle can only be used for patterns that

show

after being selected. Before you

select a stitch pattern, make sure the stitch can be
sewn in the twin needle mode (refer to the
“STITCH SETTING CHART” at the end of this
manual).

Press

and install the twin needle

(see “CHANGING THE NEEDLE” on page 39).

Manually thread the machine.

Follow the steps for threading a single needle for the
first threading (see “Threading Manually” on page
31).

Pass the thread through the needle bar
thread guides on the needle bar, then
thread the needle on the left side.

a Needle bar thread guides

Pull up the supplemental spool pin and set it
in the up position.

a Supplemental spool pin

CAUTION

• Use only twin needles made for this machine

(part code X59296-151). Other needles could
break, resulting in damage.

• Be sure to set the twin needle mode when

using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.

• Do not sew with bent needles. The needle

could break and cause injury.

• When using the twin needle, be sure to use

presser foot “J” only.

• When the twin needle is used, bunched

stitches may occur depending on the types of
fabric and thread that are used.
If this occurs, use monogramming foot “N”.

• Before changing the needle or threading the

machine, be sure to press

in the

LCD, otherwise injuries may occur if the
“Start/Stop” button or any other button is
pressed and the machine starts sewing.

Note

• The “Automatic Threading” button cannot be

used. Manually thread the twin needle from
front to back. Using the “Automatic Threading”
button may result in damage to the machine.