Руководство По Работе для Brother Innov-is 4500D
SEWING THE STITCHES
Ut
ili
ili
ty Stit
ch
es
es
67
3
■ Basting
a
a
a
a
Select
and attach presser foot “J”.
b
b
b
b
Press the “Reverse/Reinforcement Stitch”
button to sew reinforcement stitches, then
continue sewing.
button to sew reinforcement stitches, then
continue sewing.
c
c
c
c
Sew while keeping the fabric straight.
d
d
d
d
End the basting with reinforcement stitches.
Dart Seam
a
a
a
a
Select
and attach presser foot “J”.
b
b
b
b
Sew a reverse stitch at the beginning of the
dart and then sew from the wide end to the
other end without stretching the fabric.
dart and then sew from the wide end to the
other end without stretching the fabric.
*
If automatic reinforcement stitching is preset, a
reinforcement stitch will automatically be sewn at
the beginning of sewing.
reinforcement stitch will automatically be sewn at
the beginning of sewing.
a Basting
c
c
c
c
Cut the thread at the end leaving 50 mm
(approx. 1-15/16 inches), and then tie both
ends together.
(approx. 1-15/16 inches), and then tie both
ends together.
*
Do not sew a reverse stitch at the end.
d
d
d
d
Insert the ends of the thread into the dart
with a needle.
with a needle.
Memo
If you do not want to use a reinforcement
stitch at the beginning; you should lift the
presser foot, rotate the handwheel, pull up the
bobbin thread and pull a length of top and
bobbin thread out from the rear of the
machine.
stitch at the beginning; you should lift the
presser foot, rotate the handwheel, pull up the
bobbin thread and pull a length of top and
bobbin thread out from the rear of the
machine.
You can set the stitch length between 5 mm
(approx. 3/16 inch) and 30 mm (approx.
1-3/16 inches)
(approx. 3/16 inch) and 30 mm (approx.
1-3/16 inches)
a Between 5 mm (approx. 3/16 inch) and 30 mm
(approx. 1-3/16 inches)
a
a