Руководство По Работе для Brother Innov-is 40e
51
2
Pulling up the bobbin thread
When making gathers or before free-motion quilting, first pull up the bobbin thread as described below.
a
Insert the bobbin into the bobbin case.
• Refer to steps
• Refer to steps
a
through
d
of “Installing the
bobbin” on page 18.
b
Pass the bobbin thread through the slot.
Do not cut the thread with the cutter.
Do not cut the thread with the cutter.
• Leave the bobbin cover removed.
c
Turn on the sewing machine.
d
Lightly hold the end of the upper thread.
a Upper thread
e
With the needle raised, press
(needle
position button) twice.
a Needle position button
f
Carefully pull the upper thread upward to pull
out the end of the bobbin thread.
out the end of the bobbin thread.
a Upper thread
b Bobbin thread
b Bobbin thread
g
Pull out about 10 cm (4 inches) of the bobbin
thread under the presser foot toward the rear
of the machine.
thread under the presser foot toward the rear
of the machine.
a Upper thread
b Bobbin thread
b Bobbin thread
h
Turn off the sewing machine.
i
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover (A), and then press down on the
right side (B).
Insert the tab in the lower-left corner of the
bobbin cover (A), and then press down on the
right side (B).
a
a
b
a
b
A
A
B