Руководство По Работе для Brother Innov-is NS2750D
Winding/Installing the Bobbin
B-22
i
While lightly holding down the bobbin with your right
hand (1), continue guiding the thread through the slit
with your left hand (2). Then, cut the thread with the
cutter (3).
hand (1), continue guiding the thread through the slit
with your left hand (2). Then, cut the thread with the
cutter (3).
j
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the bobbin
cover, and then lightly press down on the right side.
cover, and then lightly press down on the right side.
→ The bobbin threading is finished.
Next, thread the upper thread. Continue with the
procedure in “Upper Threading” on page B-23.
procedure in “Upper Threading” on page B-23.
k
Press
to unlock all keys and buttons.
Note
• If the thread is not correctly inserted through the
tension-adjusting spring of the bobbin case, it
may cause incorrect thread tension.
may cause incorrect thread tension.
1 Tension-adjusting spring
Memo
• You can begin sewing without pulling up the
bobbin thread. If you wish to pull up the bobbin
thread before starting to sew, pull up the thread
according to the procedure in “Pulling up the
bobbin thread” on page B-27.
thread before starting to sew, pull up the thread
according to the procedure in “Pulling up the
bobbin thread” on page B-27.
1
1
2