Руководство По Работе для Brother Innov-is NQ3500D
Sewing
B-36
e
If necessary, specify the setting for automatic reverse/
reinforcement stitching and adjust the stitch length,
etc.
reinforcement stitching and adjust the stitch length,
etc.
• For details on adjusting the stitch width and length,
refer to “Setting the stitch width” on page B-40 and
“Setting the stitch length” on page B-40.
“Setting the stitch length” on page B-40.
f
Install the presser foot.
• For details on changing the presser foot, refer to
“Replacing the presser foot” on page B-33.
g
Set the fabric under the presser foot. Hold the fabric
and thread with your left hand, and rotate the
handwheel counterclockwise or press
and thread with your left hand, and rotate the
handwheel counterclockwise or press
(Needle
position button) to set the needle in the sewing start
position.
position.
h
Lower the presser foot.
You do not have to pull up the bobbin thread.
i
Adjust the sewing speed with the sewing speed
controller.
controller.
You can use this controller to adjust sewing speed
during sewing.
during sewing.
1 Fast
2 Slow
2 Slow
j
Press the “Start/Stop” button to start sewing.
Guide the fabric lightly by hand.
k
Press the “Start/Stop” button again to stop sewing.
l
Press
(Thread cutter button) to trim the upper and
lower threads.
1 Thread cutter button
→ The needle will return to the up position
automatically.
Note
• When a stitch is selected, the icon for the
presser foot that should be used appears on the
screen. Check that the correct presser foot is
attached before starting to sew. If the wrong
presser foot is installed, turn off the machine,
attach the correct presser foot, turn machine
back on and then select the desired stitch again.
screen. Check that the correct presser foot is
attached before starting to sew. If the wrong
presser foot is installed, turn off the machine,
attach the correct presser foot, turn machine
back on and then select the desired stitch again.
CAUTION
• Always use the correct presser foot. If the
wrong presser foot is used, the needle may
strike the presser foot and bend or break,
possibly resulting in injury.
Refer to page B-47 for presser foot
recommendations.
strike the presser foot and bend or break,
possibly resulting in injury.
Refer to page B-47 for presser foot
recommendations.
Memo
• The black button on the left side of presser foot
“J” should be pressed only if the fabric does not
feed or when sewing thick seams. For details,
refer to “Sewing thick fabrics” in the “Sewing”
section. Normally, you can sew without pressing
the black button.
feed or when sewing thick seams. For details,
refer to “Sewing thick fabrics” in the “Sewing”
section. Normally, you can sew without pressing
the black button.
Memo
• When the foot controller is being used, you
cannot start sewing by pressing the “Start/Stop”
button.
button.
b
a
1