Руководство По Работе для Brother Innov-is NS1150E

Winding/Installing the Bobbin

B-14

Winding the bobbin

This section describes how to wind thread onto a bobbin.

Open the top cover.

Place the bobbin on the bobbin winder shaft so that the
spring on the shaft fits into the notch in the bobbin

Press down on the bobbin until it snaps into place.

1 Notch
2 Bobbin winder shaft spring

Slide the bobbin winder in the direction of the arrow
until it snaps into place.

• The “Start/Stop” button lights up in orange.

Remove the spool cap that is inserted onto the spool
pin.

1 Spool pin
2 Spool cap

Winding/Installing the Bobbin

CAUTION

• Only use the Bobbin (part code: SA156, SFB:

XA5539-151) designed specifically for this
machine. Use of any other bobbin may result
in injuries or damage to the machine.

• The included bobbin was designed specifically

for this machine.
If bobbins from other models are used, the
machine will not operate correctly. Use only
the included bobbin or bobbins of the same
type (part code: SA156, SFB: XA5539-151).
SA156 is Class15 type bobbin.

Made of plastic

1 This model
2 Other models
3 11.5 mm (approx. 7/16 inch)

Memo

• When winding bobbin for embroidery be sure to

use the recommended bobbin thread for this
machine.