Краткое Руководство По Установке для Brother LS-30

Cleaning bobbin case

Raise the needle to its 
highest position, pull the 
latch and remove the 
bobbin case.

Troubleshooting

Remove the power plug 
from the outlet.

Slide the latch levers out 
from the retaining ring.

Remove the retaining ring.

Remove the hook by 
grasping the center post 
and pulling out. 
Note it’s position related to 
the driver.

Remove any accumulated 
lint and thread with a 
brush.

Grasp the center post of 
the hook, match the hook 
position opposite the driver 
and insert.

Insert the retaining ring 
with the notch up.

Push the latch levers into 
their locked position. 
Replace the bobbin case. 
(See A.)

∗Do not pull or push fabric while stitching. 

It may bend the needle causing it to break.

∗Do not turn the balance wheel and pull the fabric by force when the thread is entangled or the motor is locked. 

If the thread is entangled, remove the thread and fabric according to the procedure below.

Open the hinged door and look for entangled 
thread.

Cut the entangled thread with small scissors 
above the needle plate and then gently 
remove the thread and fabric.

Turn the balance wheel to raise the needle, 
then remove the fabric.

Perform steps of “Cleaning bobbin case”. 
(See D.)

∗If machine runs but needle does not move, look to be sure bobbin winding shaft is moved to the left into the sewing position.

***READ ME FIRST***

Should you encounter any problem with your product:

*DO NOT RETURN THIS PRODUCT TO THE STORE

*Please read the manual carefully. If you still need assistance, 

contact your nearest service center. 
(FOR USA/CANADA ONLY) 
Call: 877-Brother (276-8437) for Customer Service

*KEEP ALL PACKING MATERIAL AND CARTON FOR FUTURE 

TRANSPORT.

TO REPACK: FOLLOW DIAGRAM BELOW

=REPACKING=

1

2

3

4

5

6

1

2

3

4

5

6

7

8

9

1

2

3

4

XA8545-221
PRINTED IN CHINA