Руководство По Работе для Brother Innov-is XV8500D
SEWING THE STITCHES
U
tili
ty
ty
S
tit
ch
es
127
3
■ Overcasting Using Presser Foot “J”
a
Select a stitch and attach presser foot “J”.
b
Sew with the needle dropping slightly off
the edge of the fabric.
the edge of the fabric.
a Needle drop position
■ Overcasting Using the Side Cutter
(Sold Separately)
By using the side cutter, you can do overcasting
while cutting the fabric.
while cutting the fabric.
a
Select a stitch.
b
Follow the steps on page 70 to remove the
presser foot.
presser foot.
c
Thread the needle (see page 62).
Stitch
Stitch name
Presser foot
Overcasting stitch
Overcasting stitch
Overcasting stitch
Overcasting stitch
Single diamond overcast
Single diamond overcast
Note
• Fine adjustment of the stitching on the
fabric can be done with “L/R Shift”. Before
sewing your project, be sure to sew trial
stitches using the same conditions as in the
actual project.
sewing your project, be sure to sew trial
stitches using the same conditions as in the
actual project.
Memo
• For best results when sewing stretch
fabrics, decrease the pressure of the
presser foot.
presser foot.
CAUTION
• Recommended stitches are noted “S” in the
lower right corner, therefore sure to only
select one of these stitches listed below. Using
another stitch may cause the needle to hit the
presser foot and break, possibly causing injury.
select one of these stitches listed below. Using
another stitch may cause the needle to hit the
presser foot and break, possibly causing injury.
Note
• Thread the needle manually when using the
side cutter, or only attach the side cutter
after threading the needle using the
“Automatic Threading” button.
after threading the needle using the
“Automatic Threading” button.
Stitch
Stitch name
Presser foot
With side cutter
With side cutter
With side cutter
With side cutter
With side cutter