Руководство По Работе для Brother Innov-is XV8500D
CARE AND MAINTENANCE
389
10
Ap
pe
nd
ix
pe
nd
ix
f
Grasp the bobbin case, and then gently lift
out.
out.
a Bobbin case
g
Use the cleaning brush or a vacuum cleaner
to remove any lint and dust from the race
and bobbin thread sensor and the
surrounding area.
to remove any lint and dust from the race
and bobbin thread sensor and the
surrounding area.
a Cleaning brush
b Race
c Bobbin thread sensor
c Bobbin thread sensor
h
Insert the bobbin case so that the
S
mark
on the bobbin case aligns with the
●
mark
on the machine.
*
Align the S and
●
marks.
a
S mark on the bobbin case
b
●
mark on the machine
c Bobbin case
*
*
Make sure that the indicated points are aligned
before installing the bobbin case.
before installing the bobbin case.
i
Insert the tabs on the needle plate cover
into the needle plate, and then slide the
cover back on.
into the needle plate, and then slide the
cover back on.
Note
• Do not apply oil to the bobbin case.
• If lint or dust collects on the bobbin thread
sensor, the sensor may not operate
correctly.
correctly.
a
b
CAUTION
• Never use a bobbin case that is scratched;
otherwise, the upper thread may become
tangled, the needle may break, or sewing
performance may suffer. For a new bobbin
case (part code: XE5342-101 (green marking
on the screw), XC8167-551 (no color on the
screw), XE8298-001 (gray, for bobbin work)),
contact your nearest authorized Brother
dealer.
tangled, the needle may break, or sewing
performance may suffer. For a new bobbin
case (part code: XE5342-101 (green marking
on the screw), XC8167-551 (no color on the
screw), XE8298-001 (gray, for bobbin work)),
contact your nearest authorized Brother
dealer.
• Make sure that you fit the bobbin case
properly, otherwise the needle may break.
Note
• If the needle plate has been removed it is
especially important to reinstall the needle
plate and tighten the screws prior to
installing the bobbin case.
plate and tighten the screws prior to
installing the bobbin case.
b
a