Руководство По Работе для Brother Innov-is XV8550D
SEWING THE STITCHES
150
One-step buttonholes are sewn from the front of
the presser foot to the back, as shown below.
the presser foot to the back, as shown below.
a Reinforcement stitching
a
Select a buttonhole stitch, and attach
buttonhole foot “A”.
buttonhole foot “A”.
b
Mark the position and length of the
buttonhole on the fabric.
buttonhole on the fabric.
a Marks on fabric
b Buttonhole sewing
b Buttonhole sewing
c
Pull out the button holder plate on the
presser foot, and insert the button that will
be put through the buttonhole. Then tighten
the button holder plate around the button.
presser foot, and insert the button that will
be put through the buttonhole. Then tighten
the button holder plate around the button.
a Button holder plate
d
Align the presser foot with the mark on the
fabric, and lower the presser foot.
fabric, and lower the presser foot.
a Mark on the fabric
b Marks on the presser foot
b Marks on the presser foot
Memo
• The maximum buttonhole length is about
28 mm (approx. 1-1/16 inches) (diameter +
thickness of the button).
thickness of the button).
2
1
Memo
• The size of the buttonhole is determined by
the size of the button in the button holder
plate.
plate.
Note
• Pass the thread underneath the presser
foot.
• Slide the outside frame of the buttonhole
foot backward as far as possible as shown
in the illustration, making sure that there is
no gap behind the part of the foot marked
“A”. If the buttonhole foot is not slid back as
far as possible, the buttonhole will not be
sewn at the correct size.
in the illustration, making sure that there is
no gap behind the part of the foot marked
“A”. If the buttonhole foot is not slid back as
far as possible, the buttonhole will not be
sewn at the correct size.
A