Руководство По Работе для Brother Innov-is XV8550D
CREATING BOBBIN WORK (SEWING)
380
q
When you have reached the end of the
stitching area, stop the machine.
stitching area, stop the machine.
r
Raise the needle and presser foot.
s
Leaving about 10 cm (approx. 4 inches) of
thread at the ends, use scissors to cut the
threads.
thread at the ends, use scissors to cut the
threads.
a 10 cm (approx. 4 inches)
■ Finishing the thread ends
a
At the end of the stitching, use a hand
sewing needle to bring the bobbin thread
up to the wrong side of the fabric.
sewing needle to bring the bobbin thread
up to the wrong side of the fabric.
a Wrong side of fabric
b Bobbin thread
b Bobbin thread
b
Working from the wrong side of the fabric,
tie the bobbin and upper threads together
by hand. Cut away excess threads with
scissors.
tie the bobbin and upper threads together
by hand. Cut away excess threads with
scissors.
a Wrong side of fabric
b Right side of fabric
b Right side of fabric
c
If the desired results could not be achieved,
adjust the tension of the bobbin thread and
of the upper thread, and then try sewing the
stitching again.
adjust the tension of the bobbin thread and
of the upper thread, and then try sewing the
stitching again.
For more details, refer to “ADJUSTING BOBBIN
WORK THREAD TENSION” on page 385.
WORK THREAD TENSION” on page 385.
Bobbin Work Free Motion
Sewing
Sewing
If so desired, use a template or draw your design
on the stabilizer to allow for ease of stitching.
Remember, your stitches with your decorative
thread will be on the underneath side of your
fabric and the stabilizer will be on the top of the
wrong side of your fabric.
on the stabilizer to allow for ease of stitching.
Remember, your stitches with your decorative
thread will be on the underneath side of your
fabric and the stabilizer will be on the top of the
wrong side of your fabric.
*
For bobbin work free motion sewing use the
instructions for “CREATING BOBBIN WORK
(SEWING)” on page 378.
instructions for “CREATING BOBBIN WORK
(SEWING)” on page 378.
*
For information about using the free motion quilting
foot “C”, free motion open toe quilting foot “O”, or
free motion echo quilting foot “E” refer to “Free
Motion Quilting” on page 133.
foot “C”, free motion open toe quilting foot “O”, or
free motion echo quilting foot “E” refer to “Free
Motion Quilting” on page 133.
Note
• Before sewing, check that there is enough
thread in the bobbin.
Note
• Do not sew reinforcement/reverse stitches
at the end of the stitching, otherwise the
threads may become tangled or the needle
may break. In addition, it will be difficult to
pull the bobbin thread up to the wrong side
of the fabric.
threads may become tangled or the needle
may break. In addition, it will be difficult to
pull the bobbin thread up to the wrong side
of the fabric.
Note
• Do not press the “Thread Cutter” button to
cut the threads, otherwise the machine may
be damaged.
be damaged.
Note
• If it is difficult to place bobbin thread
through the eye of a hand sewing needle,
use a ribbon embroidery needle to pull the
thread up to the wrong side of the fabric.
Otherwise, use an awl to pull up the bobbin
thread.
use a ribbon embroidery needle to pull the
thread up to the wrong side of the fabric.
Otherwise, use an awl to pull up the bobbin
thread.
Note
• To ensure threads do not come undone
after being tied place a drop of fabric glue
on knots.
on knots.