Руководство По Работе для Brother PE-700II/750D(USB)

GETTING READY

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Installing the bobbin

Install the bobbin wound with thread.

CAUTION

Slide the bobbin cover latch to the right.

a Bobbin cover
b Latch

The bobbin cover opens.

Remove the bobbin cover.

Hold the bobbin with your right hand and hold
the end of the thread with your left.

• Be careful not to drop the bobbin.

Insert the bobbin into the bobbin case so that
the thread unrolls to the left.

• Be sure to insert the bobbin correctly.

CAUTION

Memo

z The order that the bobbin thread should be

passed through the bobbin case is indicated
by marks around the bobbin case. Be sure to
thread the machine as indicated.

Lightly hold down the bobbin with your right
hand, and then guide the thread as shown with
your left hand.

CAUTION

● Use a bobbin that has been correctly

wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.

● The bobbin was designed specifically for

this machine. If bobbins from other
models are used, the machine will not
operate correctly. Use only the included
bobbin or bobbins of the same type (part
code: SA156, SFB: XA5539-151).

Actual size

11.5 mm

This model

Other model

(7/16 inch)

● Be sure to install the bobbin so that the

thread unwinds in the correct direction,
otherwise the thread may break or the
thread tension will be incorrect.

● When installing the bobbin, be sure to hold

it down with your finger. If the bobbin is
not correctly installed, the thread tension
will be incorrect.