Руководство По Работе для Brother PQ1500SL
13
Stop winding process when bobbin
9
is full. Remove your foot from the
foot controller.
foot controller.
Manually move bobbin winding
0
clutch back to original position.
While holding the end of the thread,
7
press on the foot controller for a
few seconds. Once enough thread
has wound itself around the bobbin
to hold itself in place, release the
foot controller and trim the excess
thread.
few seconds. Once enough thread
has wound itself around the bobbin
to hold itself in place, release the
foot controller and trim the excess
thread.
Cut thread and remove bobbin.
A
Start winding the bobbin again by
8
pressing down on the foot controller.
�
Place the thread end so that it does
not protrude from the bobbin.
Bobbin Winding Clutch
Controller
Pedal
Press down
�
Pressing down on the controller
harder increases the winding speed.