Руководство По Работе для Brother DZ1500FL

Скачать
Страница из 60
23
Free Motion Quilting Foot
Reduce the foot pressure and turn 
the dial on the machine lowering the 
feed dog for free motion quilting.
Note
If the foot is frequently used, be 
sure to apply a small amount of 
oil about once a month to the 
area indicated by the arrows. (If 
too much oil is applied, wipe off 
the excess with a cloth.)
For best results when using 
metallic or monofilament 
threads for free motion quilting, 
sew with a good quality thread, 
set upper tension 1-2, and use 
a metallic needle.
Walking Foot
Forked part 
of operation 
lever
Secure the 
cap screw 
with a 
screwdriver.
1
2
Note
Do not press the foot controller 
all the way down.  
Try to keep the sewing speed 
low (500  r.p.m. or less).
The fabric may not feed 
properly if you sew at high 
speeds.
The feed dog for feeding the 
cloth may not move if the foot 
pressure on the fabric is too 
strong. Use the presser foot 
pressure adjustment dial to 
achieve the desired results.
It is not advisable or necessary 
to use the Pin Feed mode with 
the walking foot.
Insert the forked part of the 
1
operation lever, while raised in 
an upright position, onto the 
screw on the right side of the 
needle bar, as shown and then 
insert the cap screw.
Tighten the screw securely 
2
with a screwdriver. Tightening 
adequately is important as the 
screw might loosen due to the 
foot and forked operation lever 
vibration.