Руководство По Работе для Brother SB8000

Скачать
Страница из 212
122
UTILITY STITCHES
 — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — 
Scallop stitching
The wave-shaped repeating pattern that looks like 
shells is called “scalloping”. It is used on the collars 
of blouses and to decorate the edges of projects.
a
Attach monogramming foot “N”.
• For details, refer to “Replacing the presser 
foot” (page 44).
b
Select stitch 
27
.
• For details, refer to “Selecting stitching” (page 
51).
c
Stitch along the edge of the fabric, making sure 
not to sew directly on the edge of the fabric.
• For better results, apply spray starch the 
fabric and press with a hot iron before it is 
sewn.
d
Trim along the stitches.
• Be careful not to cut the stitches.
Smocking
The decorative stitch created by stitching or 
embroidering over gathers is called “smocking”. It is 
used to decorate the front of blouses or cuffs.
The smocking stitch adds texture and elasticity to 
fabric.
a
Attach zigzag foot “J”.
• For details, refer to “Replacing the presser 
foot” (page 44).
b
Select the straight stitch, and then adjust the 
stitch length to 4.0 mm (3/16 inch) and loosen 
the thread tension.
• For details, refer to “Adjusting the stitch 
length” (page 59) and “Adjusting the thread 
tension” (page 59).
• Pull up the bobbin thread. For details, refer to 
“Pulling up the bobbin thread” (page 39).
c
Sew parallel stitching at intervals of 1 cm 
(3/8 inch).
a 1 cm (3/8 inch)
• Do not use reverse/reinforcement stitching or 
thread cutting. 
• At the end of the stitching, the thread is 
pulled out about 5 cm (2 inches). 
d
Pull the bobbin threads to create gathers.
Smooth the gathers by ironing them.
J
1