Руководство По Работе для Brother SB4138

GETTING READY

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Remove the bobbin from the shaft.

Memo

z When the sewing machine is started or the

handwheel is turned after winding the
bobbin, the machine will make a clicking
sound; this is not a malfunction.

Installing the bobbin

Install the bobbin wound with thread.

CAUTION

Memo

z The order that the bobbin thread should be

passed through the bobbin case is indicated
by marks around the bobbin case. Be sure to
thread the machine as indicated.

Press

(“Needle Position” button) once or

twice to raise the needle, and then raise the
presser foot lever.

Turn off the sewing machine.

Slide the bobbin cover latch to the right.

a Bobbin cover
b Latch

The bobbin cover opens.

Remove the bobbin cover.

Hold the bobbin with your right hand and hold
the end of the thread with your left.

• Be careful not to drop the bobbin.

Insert the bobbin with your right hand so that
the end of the thread is on the left, and then,
after pulling the thread firmly around the tab
with your left hand as shown, lightly pull the
thread to guide it through the slit.

a Tab

CAUTION

● Use a bobbin that has been correctly

wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.

● The bobbin was designed specifically for

this sewing machine. If bobbins from other
models are used, the machine will not
operate correctly. Use only the included
bobbin or bobbins of the same type (part
code: SA156, SFB(XA5539-151)).

Actual size

11.5 mm

This model

Other model

(7/16 inch)

● Be sure to install the bobbin so that the

thread unwinds in the correct direction,
otherwise the thread may break or the
thread tension will be incorrect.