Руководство По Работе для Brother NX 600
GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
22
Installing the bobbin
Install the bobbin wound with thread.
CAUTION
Memo
z The order that the bobbin thread should be
passed through the shuttle is indicated by
marks around the shuttle. Be sure to thread
the machine as indicated.
marks around the shuttle. Be sure to thread
the machine as indicated.
a
Slide the bobbin cover latch to the right.
a Bobbin cover
b Latch
b Latch
X
The bobbin cover opens.
b
Remove the bobbin cover.
c
Hold the bobbin with your right hand and hold
the end of the thread with your left.
the end of the thread with your left.
• Be careful not to drop the bobbin.
d
Insert the bobbin into the shuttle so that the
thread unrolls to the left.
thread unrolls to the left.
• Be sure to insert the bobbin correctly.
e
Lightly hold down the bobbin with your right
hand, and then guide the thread as shown with
your left hand.
hand, and then guide the thread as shown with
your left hand.
f
Pass the thread through the slot as shown, and
then pull the thread out toward the front.
then pull the thread out toward the front.
a Cutter
X
The cutter cuts the thread.
● Use a bobbin thread that has been
correctly wound, otherwise the needle
may break or the thread tension will be
incorrect.
may break or the thread tension will be
incorrect.
● The bobbin was designed specifically for
this sewing machine. If bobbins from
older models are used, the machine will
not operate correctly. Use only the
enclosed bobbin or bobbins of the same
type (part code: SA156, SFB (XA5539-
151)).
older models are used, the machine will
not operate correctly. Use only the
enclosed bobbin or bobbins of the same
type (part code: SA156, SFB (XA5539-
151)).
Actual size
11.5 mm
This model
Older model
(7/16 inch)
1
2
1
F3dash-BrotherE_sgml.book Page 22 Friday, September 5, 2003 5:46 PM