Руководство По Работе для Brother NX 600
UTILITY STITCHES
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
84
d
Align the seam with the center of the zipper,
and then baste the zipper in place.
and then baste the zipper in place.
a Wrong side of fabric
b Basting stiching
c Zipper
b Basting stiching
c Zipper
e
Attach the presser foot holder to the right pin
of zipper foot "I".
of zipper foot "I".
a Pin on the right side
b Needle drop point
b Needle drop point
• For details, refer to "Replacing the presser
foot" (page 37).
f
Select stitch
3
.
• For details, refer to "Selecting stitching" (page
66).
CAUTION
g
Topstitch around the zipper.
a Stitching
b Right side of fabric
c Basting stitching
d End of zipper opening
b Right side of fabric
c Basting stitching
d End of zipper opening
CAUTION
h
Remove the basting stitching.
● When using zipper foot "I", be sure to
select the straight stitch (center needle
position), and slowly turn the balance
wheel toward you to check that the
needle does not touch the presser foot. If
a different stitch is selected or the needle
hits the presser foot, the needle may bend
or break.
position), and slowly turn the balance
wheel toward you to check that the
needle does not touch the presser foot. If
a different stitch is selected or the needle
hits the presser foot, the needle may bend
or break.
1
2
3
I
1
2
● When sewing, be sure that the needle
does not touch the zipper, otherwise the
needle may bend or break.
needle may bend or break.
1
3
2
4
F3dash-BrotherE_sgml.book Page 84 Friday, September 5, 2003 5:46 PM