Руководство По Работе для Brother NX-2000

11

a

When this button is pressed, the machine sews a few stitches at 
a low speed, then begins sewing at the speed set by the sewing 
speed controller. Press this button again to stop sewing. This 
button lights up in a different color depending on the machine’s 
operating condition.

b

This button is used to sew reinforcement stitches at the 
beginning and end of stitching. When this button is pressed, the 
machine sews 3 to 5 stitches in the same spot, then stops 
automatically. For straight and zigzag stitches that take reverse 
stitches, the machine sews reverse stitches (stitches sewn in 
the opposite direction) at low speed only while the “Reverse/
Reinforcement Stitch” button is held down.

c

Use this button to change the sewing direction or for detailed 
sewing in small areas. Press this button to raise or lower the 
needle position. Press this button twice to sew a single stitch.

d

Press this button after sewing to automatically trim the excess 
thread.

e

Press this button to lower the presser foot and apply pressure to 
the fabric. Press this button again to raise the presser foot.

f

Slide the sewing speed controller to the left or right to adjust the 
sewing speed. Slide the controller to the left to sew at lower 
speeds. Slide the controller to the right to sew at higher speeds.
Beginners should sew at a lower speed until they become 
familiar with the machine.

The accessories are stored in the flat bed 
attachment. Open the flat bed attachment as 
shown below.

a

b

c

Green:

The machine is ready to sew or is sewing.

Red:

The machine cannot sew.

a

b

c