Руководство По Работе для Brother NX-2000
SEWING THE STITCHES
U
tili
ty
ty
S
tit
ch
es
89
3
f
Gently hold the end of the upper thread, and
then start sewing.
then start sewing.
* Once sewing is completed, the machine
automatically sews reinforcement stitches, then
stops.
stops.
* If the automatic thread cutting setting is selected
before sewing, the machine will automatically cut
the thread at the end of stitching.
the thread at the end of stitching.
→ A buttonhole starts to sew from the front of the
presser foot to the back.
g
Insert a pin along the inside of a bar tack at
the end of the buttonhole, and then insert the
seam ripper into the center of the buttonhole
and cut towards the pin.
the end of the buttonhole, and then insert the
seam ripper into the center of the buttonhole
and cut towards the pin.
a
Pin
b
Seam ripper
For keyhole buttonholes, use the included eyelet
punch to make a hole in the rounded end of the
buttonhole. Then, insert a pin along the inside of the
bar tack, insert a seam ripper into the hole made
with the eyelet punch, and then cut towards the pin.
punch to make a hole in the rounded end of the
buttonhole. Then, insert a pin along the inside of the
bar tack, insert a seam ripper into the hole made
with the eyelet punch, and then cut towards the pin.
a
Pin
b
Eyelet punch
Note
• If the fabric does not feed, for example, because it is
too thick, press
in the length display to
increase the stitch length.
• When sewing is finished, raise the buttonhole lever
to its original position.
Note
Be careful not to cut the stitches with the seam ripper.
CAUTION
• When using the seam ripper to open the buttonhole,
do not put your hand or finger in the path of the
ripper. The ripper may slip and cause injury.
ripper. The ripper may slip and cause injury.
a
b
a
b