Руководство По Работе для Brother SC3000

45

■ If thick seams are being sewn and the fabric does 

not feed at the beginning of stitching
The fabric may not feed when thick seams are 
being sewn and the presser foot is not level, as 
shown below. In this case, use the presser foot 
locking pin (black button on the left side of zigzag 
foot “J”) so that the presser foot remains level 
while sewing, allowing the fabric to be fed 
smoothly.

a Sewing direction

a

b

c

a Presser foot locking pin (black button)

d

X

The presser foot remains level, allowing 
the fabric to be fed.

• After the seam is sewn, the presser foot will 

return to its original angle.

● Before start sewing, baste together the fabric 

and the hook-and-loop fastener tape.

Make sure that the needle passes through the hook-
and-loop fastener tape by turning the handwheel and 
lower the needle into the hook-and-loop fastener 
tape before sewing. And then, sew the edge of the 
hook-and-loop fastener tape at a slow speed.
If the needle does not pass through the hook-and-
loop fastener tape, replace the needle with the 
needle for thick fabrics (page 31). 

a Edge of the hook-and-loop fastener tape

● If fabric more than 6 mm (15/64 inch) thick is 

● Use only the ungummed hook-and-loop 

● If the hook-and-loop fastener tape is sewn