Руководство По Работе для Brother PR1050X
SELECTING/EDITING/SAVING PATTERNS
163
5
Connecting the USB using the
included USB cord clamps
included USB cord clamps
When connecting the embroidery machine to a
computer, use the included USB cord clamps to
keep the cord away from the carriage.
computer, use the included USB cord clamps to
keep the cord away from the carriage.
Included cord clamps
Installation positions of the USB cord clamps
1 Front screw hole on the side of the machine
2 Rear screw hole on the side of the machine
2 Rear screw hole on the side of the machine
a
Using the included Allen screwdriver,
remove the protective cap covering the
front screw on the side of the machine.
remove the protective cap covering the
front screw on the side of the machine.
• Insert the end of the Allen screwdriver into the hole in
the protective cap, and then lightly pull out the
protective cap to remove it.
protective cap to remove it.
b
Open the USB cord clamp.
• With your fingernail, press on the tab to open the
clamp.
1 Tab
c
Hold the clip end of the USB cord clamp,
and then firmly insert the other end into the
screw hole where the protective cap was
removed.
and then firmly insert the other end into the
screw hole where the protective cap was
removed.
d
As described in steps
a
through
c
,
remove the protective cap from the rear
screw hole on the side of the machine, and
then insert an opened USB cord clamp.
screw hole on the side of the machine, and
then insert an opened USB cord clamp.
Note
• Do not insert the Allen screwdriver too far
into the hole in the protective cap;
otherwise, the machine or the Allen
screwdriver may be damaged.
otherwise, the machine or the Allen
screwdriver may be damaged.
1
2
1