Руководство По Работе для Brother PR1050X
216
Connecting patterns to be joined
along an edge
along an edge
Greater design variations can be created by sliding
the patterns being connected.
the patterns being connected.
The following procedure describes how to use this
function to connect patterns so they are joined
along an edge. Before connecting the patterns, the
basting function will be used to measure the
distance that the pattern will be slid.
function to connect patterns so they are joined
along an edge. Before connecting the patterns, the
basting function will be used to measure the
distance that the pattern will be slid.
A: First pattern
B: Second pattern
■ Measuring the distance that the
pattern will be slid
a
Set “Basting Distance” in the settings screen
to “0.0”.
to “0.0”.
b
Select the pattern whose slide distance is to
be measured.
be measured.
c
Continue to the embroidering settings
screen, and then touch
screen, and then touch
to select the
basting function.
d
After the pattern is sewn, remove the fabric
from the frame, and then measure the
distance that the pattern is to be slid.
from the frame, and then measure the
distance that the pattern is to be slid.
1 Horizontal: 42.8 mm
2 Vertical: 32.8 mm
2 Vertical: 32.8 mm
Note
• Steps
a
through
d
are for measurement
placement only. Be sure to sew trial
embroidery using same fabric and threads
as project in order to check the
embroidering results.
embroidery using same fabric and threads
as project in order to check the
embroidering results.