Руководство По Работе для Brother PR1050X
26
Setting up the machine
When setting up the machine, adjust the legs so
that the machine is steady.
that the machine is steady.
a
Make sure that all packing tape affixed to
the machine is peeled off and that all
packing material is removed.
the machine is peeled off and that all
packing material is removed.
b
Set up the machine while making sure that
there is sufficient space around it.
there is sufficient space around it.
c
Adjust the legs so that the machine is
steady.
steady.
Use the included wrench to loosen the lock nut on the
leg that you wish to adjust.
leg that you wish to adjust.
1 Lock nut
2 Adjustable foot nut
→ The foot can be turned.
2 Adjustable foot nut
→ The foot can be turned.
d
Use the included wrench to turn the
adjustable foot nut on the foot.
adjustable foot nut on the foot.
Turning the nut in direction 1 lengthens the leg;
turning the nut in direction 2 shortens the leg.
turning the nut in direction 2 shortens the leg.
1 Adjustable foot nut
• Adjust all four legs so that they securely contact the
• Adjust all four legs so that they securely contact the
desk or table, and the machine is level.
e
After adjusting the legs to the desired
length, use the included wrench to tighten
the nuts.
length, use the included wrench to tighten
the nuts.
1 Lock nut
f
Press down on each corner of the
embroidery machine to check that it is
stable.
embroidery machine to check that it is
stable.
If it is still unstable, perform steps
c
through
e
again to adjust the legs.
Minimum of
50 mm
(2 inches)
589 mm
(23-1/4 inches)
More than
350 mm
(13-3/4 inches)
More than
210 mm
(8-1/4 inches)
560 mm
(22 inches)
More than
220 mm
(8-3/4 inches)