Руководство По Работе для Brother PR1050X
282
e
Pass the thread through the hole in the right
of the thread guide toward the back of the
machine.
of the thread guide toward the back of the
machine.
1 Hole in the thread guide
f
Wind the thread clockwise around the
bobbin 4 or 5 times, as shown in the
illustration.
bobbin 4 or 5 times, as shown in the
illustration.
g
Pass the end of the thread through the guide
slit in the bobbin winder seat, and pull the
thread. The cutter will cut the thread.
slit in the bobbin winder seat, and pull the
thread. The cutter will cut the thread.
1 Guide slit
2 Bobbin winder seat
2 Bobbin winder seat
h
Slide the bobbin holder, until it clicks into
place.
place.
1 Bobbin holder
i
Press the main power switch to start
winding the bobbin.
winding the bobbin.
→ Start winding the bobbin.
j
The bobbin will stop rotating automatically
when it is done winding, and the bobbin
holder will return to its original position.
when it is done winding, and the bobbin
holder will return to its original position.
Note
• Be sure to follow the procedure described.
If the bobbin is wound without the thread
being cut with the cutter, when the bobbin
thread runs low, the thread may become
tangled around the bobbin and cause the
needle to break.
being cut with the cutter, when the bobbin
thread runs low, the thread may become
tangled around the bobbin and cause the
needle to break.