Руководство По Работе для Brother PR-650/650C
EMBROIDERING SETTINGS ——————————————————————————————————————————————————————————————————
128
Setting the Machine to Stop at Color Changes
The machine can be stopped at any time; however, if the machine is stopped while it is embroidering, it is
better to go back a few stitches before continuing sewing to overlap the stitching. If the machine stops at a
color change, it is not necessary to go back through the stitching before continuing embroidering.
better to go back a few stitches before continuing sewing to overlap the stitching. If the machine stops at a
color change, it is not necessary to go back through the stitching before continuing embroidering.
Stopping the machine at the
next color change
next color change
The machine can be set to stop before sewing the
next color.
next color.
1
While sewing the color before the point
where you wish to stop the machine, touch
so that it changes to
.
2
After finishing sewing the area for the
current color, the next needle bar moves
into position and the machine stops before
sewing the next color.
current color, the next needle bar moves
into position and the machine stops before
sewing the next color.
X
changes back to
.
• If the machine is temporarily turned off,
you will be asked if you wish to continue
sewing or select a new pattern when the
machine is turned on again.
Touch
to continue embroidering.
(Refer to “Resume Embroidering After
Turning Off the Machine” on page 110.)
Specifying pause locations
before embroidering
before embroidering
Pause locations can be specified in the change
thread color screen, displayed by touching
.
1
Touch
in the pattern editing screen.
X
The change thread color screen appears.
2
Touch
and
so that the color at
the top of the thread color sequence display
is the color where you wish to stop the
machine before sewing it.