Руководство По Работе для Brother PR-1000
APPENDIX ————————————————————————————————————————————————————————————————————————————
252
3
Pull the table toward you until the pins on
the mounting brackets (attached on each
side to the bottom of the table) fit into the
notches in the guide plates.
the mounting brackets (attached on each
side to the bottom of the table) fit into the
notches in the guide plates.
1 Pin
2 Notch
2 Notch
4
Slide in the table while supporting it so that
it remains level. Push the table in until it
lightly touches the machine.
• If the table does not move smoothly,
it remains level. Push the table in until it
lightly touches the machine.
• If the table does not move smoothly,
slightly lift it up, and then slide it in.
5
While looking below the table, lightly lift it
up, and then lower it so that the screw fits
into the notch at the front of the guide plate.
up, and then lower it so that the screw fits
into the notch at the front of the guide plate.
1 Notch at front
6
Tighten the two thumb screws so that the
table is secured.
table is secured.
1 Thumb screw