Руководство По Работе для Brother PR-1000
APPENDIX ————————————————————————————————————————————————————————————————————————————
264
6
Lightly press down the ring, and then use the
Allen screwdriver (large) to tighten the four
hexagonal screws on the inside of the ring.
Firmly tighten the screws.
Allen screwdriver (large) to tighten the four
hexagonal screws on the inside of the ring.
Firmly tighten the screws.
1 Ring
CAUTION
7
Remove the pad inserted in step
5
.
■ Installing the needle plate spacer
Attach the needle plate spacer to the needle
plate.
plate.
1 Needle plate spacer
■ Preparing the mounting jig
Attach the mounting jig to a stable surface, such
as a desk.
as a desk.
1
Loosen the thumb screw for the mounting jig
to open the mounting bracket so that it is
wider than the thickness of the mounting
surface.
to open the mounting bracket so that it is
wider than the thickness of the mounting
surface.
• The mounting bracket can be mounted
onto a mounting surface with a thickness
from 9 mm (3/8 inch) to 38 mm (1-1/2
inches).
from 9 mm (3/8 inch) to 38 mm (1-1/2
inches).
2
Securely clamp the mounting bracket onto
the mounting surface by tightening the
thumb screw.
the mounting surface by tightening the
thumb screw.
1 Mounting bracket
2 Mounting surface
3 Tighten thumb screw
2 Mounting surface
3 Tighten thumb screw
●
Make sure that each hexagonal screw is
firmly tightened. If any screw remains
loosen, injuries may result.
firmly tightened. If any screw remains
loosen, injuries may result.