Руководство По Работе для Brother PR-1000

APPENDIX  ————————————————————————————————————————————————————————————————————————————

296

There are loops in 

the upper thread.

Thread is not correctly threaded 

around upper thread tension 

discs.

Clean upper thread tension 

disc. Rethread and make sure 

tension disc rotates when 

pulling on thread.

p.286

The thread quality is poor.

Try sewing with different 

thread. If the problem no 

longer occurs after the thread is 

changed, the thread quality is 

the problem. Replace the 

thread with one of good 

quality.

The machine is 

noisy.

Lint may be wound in the hook.

Clean the hook.

p.282

The upper thread is not 

threaded correctly.

Check the thread path, and 

then thread the upper thread 

again.

p.56

The hook is damaged.

Replace the hook.

Consult your nearest Brother 

dealer.

Not enough oil was applied.

Oil recommended parts.

p.287

The needle 

threader cannot 

be used.

The needle is not at the correct 

position.

Touch the key to move the 

desired needle bar to be 

threaded into embroidering 

position.

p.63

Recommended needles are not 

used on this machine.

Replace and use recommended 

needle.

p.35, 88

The needle is not installed 

correctly.

Correctly install the needle.

p.35, 88

The hook on the automatic 

needle-threading mechanism is 

bent.

Consult your nearest Brother 

dealer.

p.35, 88

The thread 

tension is 

incorrect.

The upper thread is not 

threaded correctly.

Check the thread path, and 

then thread the upper thread 

again.

p.56

The bobbin thread is not 

correctly threaded.

Correctly thread the bobbin 

thread.

p.38

The lower thread tension is 

incorrect.

Adjust the tension of the 

bobbin thread.

p.122

The upper thread 

comes out of the 

needle when 

embroidering 

begins.

If a short length of thread 

remains after the thread is 

trimmed, the needle may 

become unthreaded when 

embroidering begins again.

Set the remaining length of 
thread to “Long Tail” on the 
second page of the settings 
screen.

p.227

The upper thread 

does not reach 

the bobbin thread 

when 

embroidering 

begins.

There is no more thread in the 

bobbin, the thread does not 

feed from the bobbin, or the 

thread that is fed from the 

bobbin is too short.

Correctly thread the lower 

thread.

p.38

Although the 

thread is not 

broken, a broken 

thread error 

occurs and the 

machine stops.

If the thread breakage sensor in 

the thread tension disc of the 

thread tension knobs cannot 

detect that the thread is being 

fed, even if the machine is 

running, a broken thread error 

occurs and the machine is 

stopped. If the thread came out 

of the thread tension disc, even 

though the thread is not broken, 

the machine detects that the 

thread is not being fed and stops.

Clean the tension unit. 

Correctly pass the thread 

through the thread tension disc. 

If the broken thread error 

occurs after the machine is 

cleaned and rethreaded, the 

sensor may be damaged. 

Consult your nearest Brother 

dealer.

p.58, 286