Руководство По Работе для Brother SB3129
Troubleshooting 137
4
Troubleshooting
If the machine stops operating correctly, check the following possible problems before requesting service.
If the problem persists, contact your retailer or the nearest authorized service center.
If the problem persists, contact your retailer or the nearest authorized service center.
Symptom
Probable Cause
Remedy
Reference
The sewing
machine does
not operate.
The machine is not turned on.
Turn on the machine.
page 11
The start/stop button was not
pressed.
pressed.
Press the start/stop button.
page 49
The presser foot lever is raised.
Lower the presser foot lever.
–
The start/stop button was pressed,
even though the foot controller is
connected.
even though the foot controller is
connected.
Do not use the start/stop button
when the foot controller is
connected. To use the start/stop
button, disconnect the foot
controller.
when the foot controller is
connected. To use the start/stop
button, disconnect the foot
controller.
page 49
The bobbin winder shaft is pushed to
the right.
the right.
Move the bobbin winder shaft to the
left.
left.
page 21
The needle
breaks.
The needle is incorrectly installed.
Correctly install the needle.
page 35
The needle clamp screw is loose.
Use the screwdriver to firmly tighten
the screw.
the screw.
The needle is bent or blunt.
Replace the needle.
The combination of fabric, thread
and needle is not correct.
and needle is not correct.
Select a thread and needle that are
appropriate for the type of fabric
being sewn.
appropriate for the type of fabric
being sewn.
page 33
The presser foot that is used is not
appropriate for the type of stitch that
you wish to sew.
appropriate for the type of stitch that
you wish to sew.
Attach the presser foot that is
appropriate for the type of stitch that
you wish to sew.
appropriate for the type of stitch that
you wish to sew.
page 128
The upper thread tension is too tight. Loosen the upper thread tension.
page 54
The fabric is pulled too much.
Lightly guide the fabric.
–
The spool is incorrectly installed.
Correctly install the spool.
page 24
The area around the hole in the
needle plate is scratched, or has a
burr on it.
needle plate is scratched, or has a
burr on it.
Replace the needle plate.
Contact your retailer or the nearest
authorized service center.
Contact your retailer or the nearest
authorized service center.
–
The area around the hole in the
presser foot is scratched, or has a
burr on it.
presser foot is scratched, or has a
burr on it.
Replace the presser foot.
Contact your retailer or the nearest
authorized service center.
Contact your retailer or the nearest
authorized service center.
–
The shuttle is scratched, or has a
burr on it.
burr on it.
Replace the shuttle.
Contact your retailer or the nearest
authorized service center.
Contact your retailer or the nearest
authorized service center.
–
A bobbin designed specifically for
this machine is not used.
this machine is not used.
Incorrect bobbins will not work
properly. Only use a bobbin
designed specifically for this
machine.
properly. Only use a bobbin
designed specifically for this
machine.
page 18
The upper
thread breaks.
The upper thread was not threaded
correctly (for example, the spool is
not installed correctly, the spool cap
is too big for the spool being used, or
the thread has come out of the
needle bar thread hook).
correctly (for example, the spool is
not installed correctly, the spool cap
is too big for the spool being used, or
the thread has come out of the
needle bar thread hook).
Correct the upper threading.
page 24
▼