Руководство По Работе для Brother XM1010

—

Main power and sewing
light switch

This switch turns the main power and sewing light on or off.

1 Turn on (toward the ‘I’ mark)
2 Turn off (toward the ‘O’ mark)

CAUTION

Foot controller

When you press the foot controller down lightly, the
machine will run at a low speed. When you press harder,
the machine’s speed will increase. When you take your
foot off the foot controller, the machine will stop.

1 Slower
2 Faster

You should make sure that nothing is placed on the foot
controller when the machine is not in use.

CAUTION

Note

(For U.S.A. only)

● Foot Controller: Model KD-1902

This foot controller can be used on the
machine with product code 888-X73.
The product code is mentioned on the
machine rating plate.

Checking the needle

The sewing needle must always be straight and sharp
for smooth sewing.

■ Checking the needle correctly

Put the flat side of the needle on a flat surface.
Check the needle from the top and the sides.
Dispose of any bent needles safely.

1 Parallel space
2 Level surface (bobbin cover, glass, etc.)

Replacing the needle

CAUTION

Turn off the machine.

Raise the needle by turning the
handwheel toward you
(counterclockwise) so that the mark on
the wheel points up.

Lower the presser foot lever.

1 Presser foot lever

●

Do not turn on the machine while pressing
down the foot controller. The machine
may start unexpectedly and cause
personal injury or damage to the machine.

●

Do not allow pieces of cloth and dust to
build up on the foot controller. Doing so
could cause a fire or an electric shock.

●

Always turn off the machine before you
change the needle. Otherwise, injuries
may occur if the foot controller is
accidentally pressed and the machine
starts sewing.

●

Only use sewing machine needles for
home use. Other needles may bend or
break and cause injury.

●

Never sew with a bent needle. A bent
needle will easily break and cause injury.