Инструкция С Настройками для Brother PE-DESIGN 10
291
Saving Font Character Patterns
Saving Font Character Patterns
Click
, and then select [Save] from the
command list.
If no file name has been specified or if the
file cannot be found, the [Save As] dialog
box appears.
box appears.
The font character patterns are saved as .pef files.
1
Click
, and then select [Save As] from the
command list.
2
Select the [MyFont] folder at the following
location.
location.
For example, (Drive where PE-DESIGN was
installed)\Program Files (x86)\Brother\PE-
DESIGN 10\MyFont
And then type in the file name, then click [Save].
installed)\Program Files (x86)\Brother\PE-
DESIGN 10\MyFont
And then type in the file name, then click [Save].
Overwriting
a
If any part of the character pattern extends off the
Design Page, a message appears. Edit the
character pattern so that no part extends off the
character pattern so that no part extends off the
Design Page, and then save it again.
Saving with a new name
a
• The font will not be usable in the Layout &
Editing if it's stored in a different folder.
• The created font is saved in the [MyFont] folder
at the following location.
• Saved files can be used in Layout & Editing.
cc
• If Layout & Editing has already started up when
a new character is saved in Font Creator, that
character will not appear in the [Font] selector
character will not appear in the [Font] selector
list in Layout & Editing. In this case, exit Layout
& Editing, and then start it up again.