Инструкция С Настройками для Brother PE-DESIGN NEXT

148

When fill stitches or satin stitches have been specified for region sewing, the angle of the stitching over the 
region is either all in the same direction or in a direction depending on the shape. However, if the Manual 
Punch tools are used, the sewing angle can be adjusted as desired to create patterns that appear more like 
manual embroidery.

For example, if fill stitches or satin stitches have been specified for a region with the following shape, the 
stitching will appear as shown below.

If a manual punching pattern is created using the above image as a guide, the stitching will appear as shown 
below.

In addition, feathered edge settings can be specified for manual punch patterns. By reducing the stitch density 
or specifying the length of the stitching, a feathered outline can be applied to the pattern.

c

The lines drawn in the pattern 
show the direction of the stitching.
The stitching is created so that it 
turns around the center of the 
radial stitching.

A three-dimensional appearance, like the flower petals, can be 
created for the flat design of this shape.

Different variations can be applied to the flower petals.

XE8656-001.book  Page 148  Monday, May 24, 2010  5:44 PM