Инструкция С Настройками для Brother PE-DESIGN NEXT

165

• Before embroidering your design, sew a 

trial sample of the design on a scrap piece 
of fabric from your design, making sure to 
use the same needle and thread.

• Be sure to affix stabilizer material to the 

back of the fabric and tightly stretch the 
fabric within the hoop. When embroidering 
on thin or stretch fabrics, use two layers of 
stabilizer material. If no stabilizer material is 
used, the fabric may become over-
stretched or wrinkled or the embroidery 
may not be sewn correctly.

c

• Use the zigzag stitch for sewing the 

outlines in order to prevent embroidering 
outside the outlines.

• For patterns that require the hoop to be 

installed at different installation positions, 
design the embroidery pattern so that the 
various parts of the pattern overlap in order 
to prevent misalignment while 
embroidering.

■

On the first page, a complete image of the Design 
Page is printed at actual size. (However, for a 130 × 
300 mm Design Page, a reduced image of the 
Design Page is printed.) On the following pages, an 
image of each design section and its sewing 
information are printed in the sewing order.

When Actual Size is selected:

An image of the pattern in each design section is 
printed on a separate page as the corresponding 
sewing information.

When Reduced Size is selected:

An image of the pattern in each design section is 
printed on the same page as the corresponding 
sewing information.

c

Overlap

XE8656-001.book  Page 165  Monday, May 24, 2010  5:44 PM