Инструкция С Настройками для Brother PE-DESIGN NEXT
191
Des
ign Ce
nte
r
Basic Design Center Operations
When using
, click the region where the
sewing attributes are to be applied.
To change the sewing attributes, repeat steps
through
.
6
1
6
a
Note:
Sewing attributes for region cannot be
applied to open regions (regions not fully
enclosed in an outline), as shown in the
illustration below.
applied to open regions (regions not fully
enclosed in an outline), as shown in the
illustration below.
If attributes cannot be applied to a region,
return to the Figure Handle Stage and make
sure that region is closed. Edit any broken
lines with the Edit Point tool.
return to the Figure Handle Stage and make
sure that region is closed. Edit any broken
lines with the Edit Point tool.
c
“Adding lines to the figure
handle image” on page 187
handle image” on page 187
XE8656-001.book Page 191 Monday, May 24, 2010 5:44 PM