Инструкция С Настройками для Brother PE-DESIGN Ver.4,3,2

202

The application is able to detect problems that may occur before or during data transfer. Here is the com-
plete list of error messages that may appear.

1

If the card module is not correctly connected: 

2

If there is no card in the card module: 

3

If an incorrect or defective card is inserted: 

4

If a defect is detected after reading has already started, or if you remove the card while reading is 
in progress, reading will stop and this message will display: 

You should never remove a card while the red indicator light in on. If you do so, you will have to 
restart the operation from the start.
If you did not remove the card and the above message appears, then the card is defective or was 
not well inserted. Reinsert the card correctly and try reading again. If you get the same message, 
then the card is defective. Try with another card.

◆

Correct the connection between the 
card module and the computer. 
Check that the module is powered.

◆

Click 

 to start reading.

◆

Click 

 to exit.

◆

Insert a Embroidery card in the 
module.

◆

Click 

 to start reading.

◆

Click 

 to exit.

◆

Insert another Embroidery card in 
the module.

◆

Click 

 to start reading.

◆

Click 

 to exit.

◆

Click 

 to remove the message.