Инструкция С Настройками для Brother PE-DESIGN Ver.4,3,2

52

■

1

The Design Page appears on the screen as shown below.

2

Create the pattern, making sure that it meets the following conditions.

NOTE:
If a pattern does not meet the conditions mentioned above, a warning will appear when continuing 
to the next step.

With the 

 setting, the actual sewing order (including the embroidery frame installa-

tion order) is optimized as explained below.
(The 

 setting can be found on the Sew menu. The setting is turned on when a 

check mark appears in front of the setting.)

◆

Explanation of a, b, and c:

a: Embroidering area when the 

embroidery frame is installed at the 
top installation position.

b: Embroidering area when the 

embroidery frame is installed at the 
middle installation position.

c: Embroidering area when the 

embroidery frame is installed at the 
bottom installation position.

The broken lines indicate each area.

◆

The size of one pattern must be no bigger 
than 100 

´

 100 mm (or 130 

´

 180 mm).

(If the pattern is imported from Design 
Center, only these size settings are 
available.)

◆

Each pattern must completely fit within 
one single area (a, b, or c).

1: This pattern is correct since it fits 

completely within area a.

2: This pattern is correct since it fits 

completely within either area b or 
area c.

3: The size of this pattern is accept-

able, but its position must be cor-
rected since it does not fit 
completely within any of the areas. 

4: This pattern must be corrected 

since it is too large.

◆

Specify the sewing order in the same 
way that it is specified for a normal 
frame.

a

b

c

a

b

c

4

3

2

1