Инструкция С Настройками для Brother PE-DESIGN Ver.4,3,2
138
■
Export
Purpose:
Exports the data shown in the Design Page as a file of a different format (dst, hus,
exp, and pcs).
exp, and pcs).
Shortcut key:
No shortcut key for this function
Toolbar:
No button for this function
Operation:
1
Click File, then Export.
A dialog like the one shown below appears.
A dialog like the one shown below appears.
NOTE:
Some patterns installed from a card cannot be exported.
Some patterns installed from a card cannot be exported.
■
Write to Card
Purpose:
Writes your Design Page to an original card.
Shortcut key:
Toolbar:
Operation:
1
Click
File
, then
Write to Card
.
This message will display.
If the card module is not connected, this message displays.
◆
Select the drive and the folder,
and then type the file name.
and then type the file name.
◆
Select the format
(DST,EXP,PCS,HUS) in which
you wish to export the file.
(DST,EXP,PCS,HUS) in which
you wish to export the file.
◆
Number of jumps for trim:
With the DST format, jump codes are
used to indicate when the thread
must be cut in order to change the
thread color. Since the number of
codes differ depending on the sewing
machine being used, this setting
allows you to select the appropriate
value. (This setting can only be speci-
fied if the DST format is selected.)
used to indicate when the thread
must be cut in order to change the
thread color. Since the number of
codes differ depending on the sewing
machine being used, this setting
allows you to select the appropriate
value. (This setting can only be speci-
fied if the DST format is selected.)
◆
If the card is not brand new, make sure
that you want to erase the data that is
already stored on the card and click
that you want to erase the data that is
already stored on the card and click
OK
.
◆
Click
Cancel
to exit.
◆
Correct the problem, then click
Retry
.
◆
Click
Cancel
to exit.
F4