Инструкция С Настройками для Brother PE-DESIGN Ver.4,3,2
50
■
Create the pattern
1
The Design Page appears on the screen as shown below.
2
Create the pattern, making sure that it meets the following conditions.
NOTE:
If a pattern does not meet the conditions mentioned above, a warning will appear when continuing
to the next step.
If a pattern does not meet the conditions mentioned above, a warning will appear when continuing
to the next step.
With the Optimize hoop change setting, the actual sewing order (including the embroidery frame instal-
lation order) is optimized as explained below.
(The Optimize hoop change setting can be found on the Sew menu. The setting is turned on when a
check mark appears in front of the setting.)
lation order) is optimized as explained below.
(The Optimize hoop change setting can be found on the Sew menu. The setting is turned on when a
check mark appears in front of the setting.)
•
When the Optimize hoop change setting is turned on:
◆
Explanation of a, b, and c:
a: Embroidering area when the
embroidery frame is installed at the
top installation position.
top installation position.
b: Embroidering area when the
embroidery frame is installed at the
middle installation position.
middle installation position.
c: Embroidering area when the
embroidery frame is installed at the
bottom installation position.
bottom installation position.
The broken lines indicate each area.
◆
The size of one pattern must be no bigger
than 100
than 100
×
100 mm (or 130
×
180 mm).
(If the pattern is imported from Design
Center, only these size settings are
available.)
Center, only these size settings are
available.)
◆
Each pattern must completely fit within
one single area (a, b, or c).
one single area (a, b, or c).
1: This pattern is correct since it fits
completely within area a.
2: This pattern is correct since it fits
completely within either area b or
area c.
area c.
3: The size of this pattern is accept-
able, but its position must be cor-
rected since it does not fit
completely within any of the areas.
rected since it does not fit
completely within any of the areas.
4: This pattern must be corrected
since it is too large.
◆
Specify the sewing order in the same
way that it is specified for a normal
frame.
way that it is specified for a normal
frame.
a
b
c
a
b
c
4
3
2
1