Руководство По Работе для Brother SB3734T

English

5.  Set the stitch length control lever.

- Tapes: between "3" and "4"
- Elastics: "4"

6.  Adjust the presser adjusting dial 2

- at "0" when sewing with tapes.
- at desirable number for contraction when 

sewing with elastics.

7.  Make trial sewing and adjust thread tensions.

Example of proper sewing seam:

<B>

<A>

<C>

<D>

 <A> 

Surface

 <B> 

Tape

 <C> 

Surface

 <D> 

Elastic

By using the pearl sequence foot, you can 
bead on fabric. It is useful for decorated edge of 
curtain, table cloth, dress, etc. From 3mm to 5mm 
sequential pearl can be sewn with this foot.

LS

1.  Retract the knife (see CHAPTER 1 "Retracting 

knife").

2.  Attach the pearl sequence foot (see CHAPTER 

1 "Attaching/ Removing presser foot").

3.  Set up the machine for 3 thread overlock stitch 

with one needle in the left position.
The right needle should be removed.

1.  Adjust the stitch length according to the length 

as <A> or <B>. For example, 4mm stitch length 
means 4mm for <A> or <B>. 

<A>

<B>

<A>
<B>

2.  Adjust stitch width 3 to 5mm.

3.  Adjust thread tension as follows:

Needle thread: slightly decrease
Over looper thread: slightly decrease
Under looper thread: slightly increase

1 ~ 1.5mm

1

2

3

1.  Fold the fabric according to the line for pearl 

fi tting.

2.  Place the fabric at needle dropping point 

keeping the folded edge with guide 1.

3.  Use the screw 2 and adjust the clearance 

between folded edge needle so that it becomes 
1mm to 1.5mm. 

4.  Place the pearl through the guide just front of 

guide tunnel 3.

1.  Sew turning hand wheel by hand until the pearl 

comes through the tunnel.

2.  Sew at slow speed while guiding the pearl and 

fabric by hand.

3.  Tie both end of thread at the beginnig and end.