Руководство По Работе для Brother 3534DT

1.  Insert the three-pin plug into the socket on the 

bottom right side of the machine. Insert the 
power supply plug into a power outlet.

2.  Turn the main power and light switch <A> to "I" 

mark (to "O" mark to turn off). 

<A>

When the foot controller is pressed lightly, the 
machine runs at a low speed. As the foot controller 
is pressed further, the machine will increase 
speed. When the foot controller is released, the 
machine stops. 

The hand wheel <A> turns in a counterclockwise 
direction (direction of arrow). This is the same 
direction as an ordinary home sewing machine.
The needles move to their highest positions by 
turning the hand wheel so that the mark <B> 
on the hand wheel is aligned to the line on the 
machine.

<A>

<B>

It is necessary to open the front cover when 
threading this machine. Slide it to the right 1 and 
open 2, or close it and slide it to the left.

For your safety, make sure that the front cover is 
closed when operating the machine.

Always turn off the machine before opening the 
front cover.

1

2

1.  Turn off the main power and light switch or 

disconnect the electric supply plug.

2.  Raise the presser foot lever. 1

3.  Turn the hand wheel 2 so that the mark on 

the hand wheel is aligned to the line on the 
machine. (See CHAPTER1 "Turning direction 
of hand wheel".)

4.  Push the button on the presser foot holder and 

the standard presser foot will be released. 3 4

5.  Raise the presser foot farther by pushing the 

presser foot lever upward. Then remove the 
presser foot and store it in a safe location.

6.  Again, raise the presser foot farther by pushing 

the presser foot lever upward. Then place the 
presser foot just under the presser foot holder 
<A> so that the groove in the bottom of the 
presser foot holder <B> is aligned and catches 
the bar on the top of the foot <C>. Then lower 
the presser foot lever to attatch the foot, 
pushing the button on the presser foot.

<A>

<C>

<B>

1

1

2

3

2

4

4